To properly display this page you need a browser with JavaScript support.
Completed Wire Harness Modification
Fuel Filler Cap While doing this work, tie the fuel tank back out of the way with a bungi cord.
Engine Control Unit If possible, do not disconnect the plugs from the ECU, since they are water sealed and it is better to leave them connected to preserve the original factory water seal.
Completed RPM / Speed Tap Connection This shows tap connections completed with wires taped to harness as a strain relief.
Completed Harness Modification Tape extension wires to harness to protect them all the way to reinforced nylon shield.
Speed / RPM Signal Connector This will connect to the HM Quickshifter GP's RPM / Speed Input Connector.
